Agilent Technologies HP 54601B Guia do Utilizador descarregar pdf (Página 34)

To edit an individual pixel of a mask

1 Press Print/Utility twice.

2 Press the Sequence Admin softkey.

3 Press the Mask Editor softkey.

4 To select the mask to be modified, press the Edit Mask softkey, or

turn the channel 1 position knob.

5 Toggle the Edit Line softkey to select the limit line that you want to

edit.

6 Turn the Delay knob to move the cursor to the pixel that you want to

modify.

7 Turn the knob closest to the Cursors key to edit the vertical position

of the pixel.

Pixel editing operating hint

The time and voltage shown at the bottom of the screen corresponds to the

current time base and vertical setting of lowest number of all active channels.

If the mask is voltage and time dependent, make sure that the current time base

and vertical setting are the same as the one that you are going to use during

the actual testing.

Operating the Test Automation Module

To edit an individual pixel of a mask

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 122 123

Sem comentários

Agilent Technologies HP 54601B Guia do Utilizador Página 34