Agilent Technologies 8000 Series Especificações descarregar pdf (Página 70)

Chapter 4: Calibrating and Adjusting

To run the self calibration

Figure 4-1

Calibration Dialog

Connect an adapter to each end of the cable.

4 Select Start, then follow the instructions on the screen.

You will be asked first to disconnect all channels and the Aux Output (located on the rear panel

of the oscilloscope), then to connect Aux Out to each channel and the auxiliary trigger in turn.

After you complete each cable change, select OK in the dialog box to continue the calibration.

The oscilloscope displays a Passed/Failed message as each calibration routine is completed.

Select Close.

Clear Cal Memory Protect to Run self calibration

You cannot run self calibration if this box is checked.

If calibration fails

Go to chapter 5 “Troubleshooting.”

Clear this check

box before starting

calibration

Select here to start

calibration

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 161 162

Sem comentários

Agilent Technologies 8000 Series Especificações Página 70