Agilent Technologies FS2010 Manual de Serviço descarregar pdf (Página 315)

Agilent Signal Generators Programming Guide 307

6 Creating and Downloading User–Data Files

NOTE Some features apply to only the E4438C with Option 001, 002, 601, or 602 and E8267D with

Option 601 or 602. These exceptions are indicated in the sections.

On the Agilent MXG, the internal baseband generator speed upgrade Options 670, 671, and

672 are option upgrades that require Option 651 and 652 to have been loaded at the factory

(refer to the Data Sheet for more information). Any references to 651, 652, or 654 are

inclusive of 671, 672, and 674.

The following sections and procedures contain remote SCPI commands. For front panel key

commands, refer to the User’s Guide, Key and Data Field Reference (ESG and PSG), or to

the Key Help in the signal generator.

For the N5161A/62A the softkey menus and features mentioned in this chapter are only

available through the Web–Enabled MXG or through SCPI commands. Refer to “Using the

Web Browser” on page 11 and to the SCPI Command Reference.

This chapter explains the requirements and processes for creating and downloading user–data, and

contains the following sections:

• User File Data (Bit/Binary) Downloads (E4438C and E8267D) on page 315

• Pattern RAM (PRAM) Data Downloads (E4438C and E8267D) on page 338

• FIR Filter Coefficient Downloads (N5162A, N5182A, E4438C and E8267D) on page 352

• Using the Equalization Filter (N5162A and N5182A with Options 651, 652, 654 Only) on page 356

• Save and Recall Instrument State Files on page 357

• User Flatness Correction Downloads Using C++ and VISA on page 368

• Data Transfer Troubleshooting (N5162A, N5182A, E4438C and E8267D Only) on page 372

1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 395 396

Sem comentários

Agilent Technologies FS2010 Manual de Serviço Página 315