Agilent Technologies EXG Especificações descarregar pdf (Página 158)

5-20 Troubleshooting Plug-in Modules

$JLOHQW0$996HULHV6HUYLFH*XLGH

Troubleshooting Plug-

in Modules

❏ If a "LQVWHDGRIDQXPHULF and a INOP message is displayed for the TEMP

module, perform the following actions:

3OHDVHQRWHWKDWIRUSURFHHGLQJWRWKHQH[WVWHSVDWUDQVGXFHUPXVWEHFRQQHFWHGWRWKH

PRGXOH

6WHS Perform a Self-Test (See “Performing the Temperature Module Self-Test” on

page 5-45). If the TEMP test numeric reads exactly the listed value, proceed to the

next step, if not, replace the module.

6WHS Refer to the following table. Correct the possible cause identified by the INOP

message and verify that the INOP disappears. If the problem still exists, replace the

module.

7DEOH,1230HVVDJHVIRUWKH7HPS0RGXOH

,1230HVVDJH 3RVVLEOH&DXVH &RUUHFWLYH$FWLRQ

<Tx> UNPLUGGED TEMP module is unplugged from the

rack.

Perform Step 5 on page 5-19.

<Tx> NO TRANSDUC Temperature probe disconnected from

the module.

Connect Temperature probe to

module.

<Tx> OVERRANGE Temperature out of range <-1

C or

>45

Replace Temperature probe.

If problem still persists, replace

module.

<Tx> EQUIP MALF Malfunction in the TEMP module hard-

ware

Replace module.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 357 358

Sem comentários

Agilent Technologies EXG Especificações Página 158