Agilent Technologies EXG Especificações descarregar pdf (Página 118)

$JLOHQW0$996HULHV6HUYLFH*XLGH

8VLQJ6XSSRUW )XQFWLRQV

Using

Support Functions

6\VWHP&RQILJXUDWLRQ3UREOHPV

This section tells you how to troubleshoot configuration problems identified in the error code

listing.

3URFHGXUHV

In general, the procedure for your configuration requires you to perform some visual checks,

verify you are operating with the proper software revision for your Monitor, and then perform

fault isolation procedures.

1. Verify the correct EEPROM part number by:

a. checking the number displayed in the “Monitor Revision” screen or,

b. using the cloning tool if the monitor is rebooting continuously or the display is

blank.

2. If the part number is correct, reprogram the EEPROM to the factory defaults using the

programming tool.

3. If the part number is incorrect, reprogram the Flash EPROM using the Programming

Tool.

4. If the preceding actions do not correct the problem replace the System Board.

6\VWHP+DUGZDUH6RIWZDUH3UREOHP5$03UREOHP

This section shows you how to fix problems that are of a hardware\software nature. The

procedure for fixing these type of problems differs based on the type of error code received.

3URFHGXUHV

1. If you get an error code in the Status Log, go to the Service Mode and execute the

extended test. If the test identifies a hardware fault, replace the System Board.

2. If the Monitor reboots continuously, perform the following:

a. Reprogram the Flash EPROM using the Programming Tool.

b. Reprogram the EEPROM.

c. If the preceding actions do not correct the problem, replace the System Board.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 357 358

Sem comentários

Agilent Technologies EXG Especificações Página 118