Agilent Technologies E8267D PSG Manual do Utilizador Página 7

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 71
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 6
lpErrorDoc.txt
-321 Out of memory; ARB is not functional.
There is insufficient memory for the ARB to generate the requested
waveform.
-321 Out of memory; BBG 3GPP cannot function properly.
3GPP cannot function properly due to dynamic memory allocation
failure.
-321 Out of memory; Burst shape subsystem unable to operate.
Operations on a Burst Shape could not be completed because of
insufficient memory.
-321 Out of memory; Cannot convert binary file to bit file.
There is not enough memory to convert a binary file to a bit file.
Reduce the size of any sweep lists and try again.
-321 Out of memory; Cannot precalculate frequencies. Try fewer frequencies.
Indicates that memory was exhausted during frequency precalculation
(used to speed the process of sweep/list mode). List mode cannot
run until either fewer frequencies have been supplied or more
memory becomes available and the same set of frequencies are sent
again, FREQ:MODE CW is executed, or :FREQ:MODE LIST is executed.
-321 Out of memory; Complementary Cumulative Distribution Display cannot
function.
There is insufficient working memory available. Report this error
to Agilent Technologies.
-321 Out of memory; Could not copy current instrument state.
An instrument state operation, such as save/recall, could not
allocate enough space to copy an instrument state. The operation is
aborted.
-321 Out of memory; Could not perform channelization code conflict test.
This error is reported when an attempt to check WCDMA DL channels
for conflicting channelization codes fails due to an out of memory
error.
-321 Out of memory; Display system out of memory. An abnormal display may
result. Memory consumption should be reduced.
There was not enough memory in the system to properly update the
display. Some inconsistencies may be seen. The size of any
list/sweep should be reduced, and the source should be preset to
clear up any inconsistencies. Report this error to Agilent
Technologies.
-321 Out of memory; FFT subsystem unable to function.
There is insufficient working memory available. Report this error
to Agilent Technologies.
-321 Out of memory; FILE NAME
Page 2
Vista de página 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 70 71

Comentários a estes Manuais

Sem comentários