Agilent Technologies E5500 Series Guia de Instalação descarregar pdf (Página 18)

1-10

Agilent Technologies E5500B Installation Guide

Welcome to the E5500B Phase Noise Measurement System Series of

Solutions

Step 2d- Installing the

Interface Cards

Installing the GPIB Interface Card

10. Insert the GPIB interface edge connector into the expansion slot

connector of the computer. Make sure the interface is fully seated by

pushing firmly on the edge of the card with the palm of your hand. The

GPIB connector should extend through the back panel opening to allow

cable installation.

NOTE Use of a GPIB connector extender may be necessary for adequate clearance

between the GPIB cable and the computer chassis.

11. Replace the GPIB back-panel cover plate screw to hold the interface in

place. (Save the blank cover plate for use if the interface is removed

later.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 50 51

Sem comentários

Agilent Technologies E5500 Series Guia de Instalação Página 18