Agilent Technologies E6392B Guia do Utilizador Página 135

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 134
134 Chapter 3
Screen Reference
MANUAL TEST (GPRS Mode)
Screen Fields
The following input fields of the parameters need to be specified for a new
spectrum test:
Input Field Description
Channel
a
a. The variable increment softkey is activated. Refer to "Variable Incre-
ment Softkey" on page 60.
Specifies one traffic channel to be analyzed. The frequency
corresponding to the channel accompanies. The allowable range is
as follows:
GSM900: 1 to 124
E-GSM: 0 to 124, and 975 to 1023
DCS1800: 512 to 885
PCS1900: 512 to 810
PWR CNTL Specifies one of the factors defined for Power Control Levels
according to the Radio Standard. The allowable factor ranges are
as follows:
GSM900 and E-GSM: 2 (+39 dBm) to 19 (+5 dBm)
DCS1800: 29 (+36 dBm) to 31 (+32 dBm), and 0 (+30
dBm) to 15 (+0 dBm)
PCS1900: 30 (+33 dBm) to 31 (+32 dBm), and 0 (+30
dBm) to 15 (+0 dBm)
Span 0 to 400 kHz (fixed)
RBW Selects either 10 kHz or 30 kHz resolution bandwidth as follows:
o 10: Sets the resolution bandwidth to 10 kHz.
o 30: Sets the resolution bandwidth to 30 kHz.
Averaging
a
Specifies the averaging number of measurements from 2 to 99,
unless Off is selected.
DC Power
a
The supply mode is dependent on the setting in the Stand-by
screens.
Accepts a dc voltage value ranging from 3.0 to 11.0 V in 0.1 V
steps. This value is used among the AUTOMATIC TEST,
MANUAL TEST, SPECTRUM MONITOR, and SIGNAL
GENERATOR modes in common.
BS Level
a
Specifies the RF output level of the Test Set, ranging from 110.0
to 50.0 dBm. The default value is set on the Test Condition screen
in the CONFIGURATION mode.
Vista de página 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 205 206

Comentários a estes Manuais

Sem comentários