Agilent Technologies 1100 Series Informações Técnicas descarregar pdf (Página 20)

Specifying the TCP/IP Settings and the BCD Board Location

Specifying the TCP/IP Settings

12 Agilent 1100 Series Connecting the Hardware and Triggering Data Acquisition Thermo Scientific

5. In the General page, select the Contact Board Installed check box.

6. Do one of the following:

• If you have not already specified the TCP/IP settings for the Agilent 1100 Series

stack, leave the General page open and go to the next procedure.

• If you have finished specifying the configuration options for the stack, click OK to

save the settings and close the dialog box. Click Done to exit the Xcalibur Instrument

Configuration program. Open the Xcalibur data system before you turn on the

devices of your Agilent1100 Series LC stack.

Specifying the TCP/IP Settings

Y To specify the TCP/IP settings for the Agilent 1100 Series stack

1. From the Instrument Configuration window, open the General page for the autosampler

(Figure 6).

Figure 6. Agilent1100 Autosampler dialog box

2. In the TCP/IP area, do the following:

• In the Stack MAC address box, type the media access control address for your

Agilent LC stack.

The stack MAC address is a unique identification for each network card. The

manufacturer usually stamps it on the network card.

Note If you do not select the Contact Board Installed check box, the Timed Events

page does not appear in the Instrument Setup view for the autosampler.

12-digit hexadecimal number

located on the back of the

HP JetDirect network card

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Sem comentários

Agilent Technologies 1100 Series Informações Técnicas Página 20