Agilent Technologies 437B Manual do Utilizador descarregar pdf (Página 3)

... yet more useful functions ...

SCPI compatible - EPM power meters conform to the

Standard Commands for Programmable Instruments

(SCPI).

RS232/422 interface - both RS232 and RS422 serial

interfaces can be used to remotely control the EPM

series power meters.

Limit testing - EPM series power meters can be

configured to verify the power being measured

against an upper and / or lower limit. Limit failures

are indicated on the power meter’s display and over

the GPIB.

Zero/Cal lockout - can be enabled to prevent the

EPM series power meter from making measure-

ments until the connected sensor is zeroed and

calibrated.

Channel offset - EPM series power meters can

be configured to compensate for signal loss or

gain in your test setup.

Designed for Manufacturing

Fast speed means increased productivity

Fast measurement speed is essential in the high

volume manufacturing of RF and microwave compo-

nents and systems. Faster test time improves your

productivity—letting you test more devices in less

time. E-series sensors along with the E4418B

power meter provide a FAST measurement mode

that lets you make up to 200 readings per second.

There’s also a x2 mode with the EPM series

power meters and 8480 series sensor combina-

tion—doubling your speed compared to the

437B and 8480 series combination.

No more slow range switch delays!

A common problem with most power meters

is the time delay that occurs when the power

being measured crosses a range switch point.

Range switching delays are either significantly

reduced or eliminated when an EPM series

power meter is used with an E-series sensor.

This power measurement combination has

only one fast range switch point across the

entire dynamic range of the sensor.

Height and width compatibility allows

easy replacement in rackmount systems

The EPM series power meters are the same

height and width as the 437B and 438A—

making them easy to substitute in rackmount

systems. The following options are available

Option 002 - rear panel sensor input(s) with

the Power Reference Calibrator

on the front panel.

Option 003 - rear panel sensor input(s) with

the Power Reference Calibrator

on the rear panel.

Option 908 - rackmount kit for one instrument.

Option 909 - rackmount kit for two instruments.

These options are available for an extra cost.

Rigorous environmental testing and high-reliability qualifies the

EPM power meters for your most demanding measurement applica-

tions.

1 2 3 4 5 6 7 8 9 10

Comentários a estes Manuais

Sem comentários

Agilent Technologies 437B Manual do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Multímetros Agilent Technologies 437B