Agilent Technologies 22D Especificações descarregar pdf (Página 37)

2-13

Preparing the Oscilloscope for Use

To verify basic oscilloscope operation

1 Connect an oscilloscope probe to channel 1.

2 Attach the probe to the Probe Comp output on the lower-right side of

the front panel of the oscilloscope.

Use a probe retractable hook tip so you do not need to hold the probe.

3Press the Save/Recall key on the front panel, then press the Default Setup

softkey under the display.

The oscilloscope is now configured to its default settings.

4Press the Autoscale key on the front panel.

You should then see a square wave with peak-to-peak amplitude of about 5

divisions and a period of about 4 divisions as shown below. If you do not see

the waveform, ensure your power source is adequate, the oscilloscope is

properly powered-on, and the probe is connected securely to the front-panel

channel input BNC and to the Probe Comp calibration output.

Verifying Basic Oscilloscope Operation

service.book Page 13 Wednesday, December 18, 2002 8:35 AM

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 117 118

Sem comentários

Agilent Technologies 22D Especificações Página 37