Agilent-technologies Wireless Network Optimization Platform E6474A Manual do Utilizador descarregar pdf (Página 33)

Set Up Your System 3

Agilent E6474A User’s Guide 33

Refer to “Installing the PDM in the Vehicle" on page 186 for

more information about PDM in- vehicle installation.

Using a Combiner antenna connection (Agilent W1314A)

Use a combiner to obtain signals from two different

antennas.

For some options of receivers, a single antenna cannot

provide coverage for all available bands. These receivers are

supplied with two antennas and a combiner. In situations

where multiple bands need to be scanned, you will need to

use the combiner to provide adequate RF signal strength.

Connect the receiver to the combiner unit using the SMA

(M) to N- Type (M) cable. Then connect the two antennas to

the combiner unit using the SMA (M) to N- Type (F)

connector adapters. Refer to Figure 14 on page 34.

NOTE

The combiner and cables add insertion loss, slightly reducing the

sensitivity of the receiver.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 193 194

Sem comentários

Agilent-technologies Wireless Network Optimization Platform E6474A Manual do Utilizador Página 33