Agilent Technologies E8403A Guia de Instalação descarregar pdf (Página 49)

Modifying an Existing ParBERT System Setting Up ParBERT

Agilent 81250 ParBERT Installation Guide, February 2002 49

Figure 27 Analyzer Frontend of an E4861A Module

Your frontends may appear differently than shown in the above figures.

For example, frontends for E4832A modules are much smaller.

Frontends for E4861B modules look as illustrated below:

Figure 28 Generator Frontend of an E4861B Module

Figure 29 Analyzer Frontend of an E4861B Module

NOTE A main difference between generators and analyzers is that analyzer

frontends have also a receiver plug-in board.

When you are removing an analyzer frontend, make sure that you also

remove the receiver board.

Receiver board

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 103 104

Installation Guide 1
Safety Summary 2
Contents 3
Setting Up ParBERT 43G 57 4
Declaration of Conformity 99 5
About this Guide 7
Contents of This Guide 8
Document History 9
Getting Started 11
ParBERT Overview 12
Mainframes 13
Controller Options 13
Software Components 19
Not Recommended Combinations 20
The ParBERT Approach 21
Basic Installation Procedure 23
ParBERT Local Configurations 23
Operating ParBERT via the LAN 26
Once You are Finished 27
Installation Prerequisites 28
Setting Up ParBERT 31
Unpacking ParBERT 32
Connecting the Peripherals 34
Setting Up a System with 35
Expander Frames 35
Placing the Mainframes 36
Expander Frame 37
Master Frame 38
1394 Links 39
Extenders 41
How to Remove a Module 44
How to Add a Module 44
LOGICAL ADDRESS 46
How to Open a Module 47
Removing a Frontend 50
Installing a Frontend 52
Hardware 56
Setting Up ParBERT 43G 57
ParBERT 43G Components 58
Setup Procedure 60
Connections of the MUX/DEMUX 61
Special Configurations 63
Clock Connections 64
43.2G Pattern 65
Generator Bundle 65
38 .. 43.2 Gb/s 65
Clock Provided by the DUT 66
Clock (675MHz 67
User Software 70
Updating the Firmware (BIOS) 72
Configuring ParBERT 76
Selecting the Operating Mode 77
Users Only) 79
Selecting the I/O Interface 80
Build Systems 81
Starting the ParBERT User 84
Software 84
How to Select the System 85
How to Get Help 88
Testing ParBERT’s Integrity 89
Connecting ParBERT to the LAN 91
Factory Default Settings 92
Configuring ParBERT for LAN 92
<your_domain> 93
<your_computer_name> 93
<your_workgroup> 93
<your_IP_addr> 94
<your_subnet> 94
<your_Gateway> 94
Problems at the Power-On 95
Selftest 95
Problems after Changing the 96
Problems with Clockgroups 97
Declaration of Conformity 100
Edition 2.1 104
81250-91010 104

Comentários a estes Manuais

Sem comentários

Agilent Technologies E8403A Guia de Instalação Página 49

Comentários a estes Manuais