Agilent Technologies E8403A Guia de Instalação descarregar pdf (Página 43)

Modifying an Existing ParBERT System Setting Up ParBERT

Agilent 81250 ParBERT Installation Guide, February 2002 43

Modifying an Existing ParBERT

System

This section provides the information you need if you are changing the

configuration of an existing ParBERT system.

The information is organized as follows:

• ”How to Remove a Module” on page 44

• ”How to Add a Module” on page 44

• ”How to Set the Logical Addresses” on page 45

• ”How to Open a Module” on page 47

• ”How to Add or Exchange a Frontend” on page 48

• ”How to Connect the Trigger Input Pod” on page 54

• ”How to Proceed After Changing the Hardware” on page 56

It is recommended that you keep track of the modules in each mainframe

with a table similar to the one shown below. This table then has to be

updated whenever the ParBERT configuration is changed.

Table 3 Mainframe Configuration Table

Slot Model number Instrument name Logical address Serial number

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 103 104

Sem comentários

Agilent Technologies E8403A Guia de Instalação Página 43