Agilent-technologies N3970A Manual do Utilizador descarregar pdf (Página 20)

N3970A UM-1

■ STORING & RECALLING READINGS

The memory location is shown at the top right of the display.

When storing data, the memory automatically increments to

facilitate the collection of data on a job.

You can also go back and over-write particular records.

After the data has been recorded, the entire memory can be

cleared ready for the next job.

Memory operating sequence

Store data in next location: push STORE

Store data starting at a particular location: push SELECT, +/-,

SET, STORE

The memory can not be read in Autotest mode. Exit Autotest

before reading the memory.

Read from any location: push RECALL, +/-. To display the

relative value, push ABS/REL, and to display the reference, hold

down ABS/REL.

Clear the whole memory: push CANCEL and RECALL together

for 2 seconds. CLR will display.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 46 47

Sem comentários

Agilent-technologies N3970A Manual do Utilizador Página 20