Agilent-technologies 66001A Manual do Utilizador Página 20
- Página / 55
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
20 Installation
Installing The Module In The Mainframe
Figure 2-3. Power Module Installation
Note A fully loaded mainframe can weigh over 36 kg (80 lbs). Install the mainframe into the rack (see the
"Mainframe Users Guide") before installing the modules into the mainframe.
1. Turn off the mainframe power switch.
2. Make certain the pull tab extends from the module (see Figure 2-3).
3. Slide the module into the mainframe slot. You may use any available slot.
4. Push the module into the backplane connector until you feel the module connector snap into the backplane connector.
5. Push the lock tab into the front of the module. If the module is not properly plugged into the backplane connector, the
lock tab will not retract into the module.
6. If desired, mark or label the power module with its slot address.
Important Marking or labeling the power module will prevent replacing it in the wrong slot if it is subsequently
removed from the mainframe. Also, with two mainframes linked together, a slot can be either of two
numbers, depending on whether it is in the main or the auxiliary mainframe (see "Connecting the
Controller" in this chapter).
Connecting The Load
Output Connector
One output connector (see Table 1-3) is shipped with each power module. This can be either a standard or relay type. The
Installation Guide supplied with the connector shows how to open the connector, connect the wires, and secure the
connector to the mainframe.
- 1
- CERTIFICATION 2
- WARRANTY 2
- LIMITATION OF WARRANTY 2
- EXCLUSIVE REMEDIES 2
- ASSISTANCE 2
- SAFETY SUMMARY 3
- Printing History 4
- DECLARATION OF CONFORMITY 5
- Table of Contents 7
- Table of Contents (continued) 8
- General Information 9
- Accessories 10
- Description 10
- Installation 17
- Connecting The Load 20
- Connecting The Controller 26
- Turn-On Checkout 27
- Power Module Turn-On State 28
- In Case Of Trouble 29
- Basic Power Module Commands 31
- Changing The Power On State 34
- Calibration 35
- Equipment Required 36
- Calibrating Voltage 36
- Calibration Error Messages 38
- Introduction 41
- Connecting The Keyboard 41
- Keyboard Description 42
- Using The Display 45
- Sending SCPI Commands 46
- SCPI Command Tree 49
- Index (continued) 52
- Manual Updates 55
Melissa 240-100 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Odkurzacze Melissa 240-100.
Dostarczamy 1 pdf podręczników Melissa 240-100 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentários a estes Manuais