Agilent Technologies E1345A Manual do Utilizador descarregar pdf (Página 54)

Relay Multiplexer Command Reference 55

INITiate

The INITiate subsystem selects continuous scanning cycles and starts the scanning

cycle.

Subsystem Syntax INITiate

:CONTinuous <

mode>

:CONTinuous?

[:IMMediate]

:CONTinuous

INITiate:CONTinuous <mode> enables or disables continuous scanning cycles for

the switchbox.

Parameters

Comments • Continuous Scanning Operation: Continuous scanning is enabled with the

INITiate:CONTinuous ON or INITiate:CONTinuous 1 command. Sending the

INITiate[:IMMediate] command closes the first channel in the channel list. Each

trigger from a trigger source selected by the

TRIGger:SOURce command

advances the scan through the channel list. A trigger at the end of the channel

list closes the first channel in the list and the scan cycle repeats.

• Non-Continuous Scanning Operation: Non-Continuous scanning is enabled

with the

INITiate:CONTinuous OFF or INITiate:CONTinuous 0 command.

Sending the

INITiate[:IMMediate] command closes the first channel in the

channel list. Each trigger from a trigger source selected by the

TRIGger:SOURce command advances the scan through the channel list. A

trigger at the end of the channel list opens the last channel in the list and the

scanning cycle stops.

• Stopping Continuous Scans: See the ABORt command.

• Related Commands: ABORt, ARM:COUNt, TRIGger, TRIGger:SOURce

• *RST Condition: INITiate:CONTinuous OFF

Example Enabling Continuous Scans

INIT:CONT ON

Enables continuous scanning.

SCAN (@100:115)

Sets channel list.

INIT

Starts scanning cycle.

Parameter Name Parameter Type Range of Values

mode>

boolean 0|1|ON|OFF

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 92 93

Sem comentários

Agilent Technologies E1345A Manual do Utilizador Página 54