Agilent Technologies 71501D Manual do Utilizador descarregar pdf (Página 119)

3-39

Eye-Diagram Analyzer Reference

Saving to Mass Storage

To Change a

Memory Card

Battery

The memory card’s battery is a lithium commercial CMOS type, part number

CR 2016.

The memory card should be installed when the battery is removed. If the bat-

tery is removed while the card is not installed, all data in the card will be lost.

Store memory-card files on another device before changing the battery, when

extra care is appropriate.

1 Install the memory card into the 70004A display.

2 On the front edge of the card, locate the groove of the battery clip.

3 Gently pry the battery clip out of the card. The battery fits inside the clip.

4 Replace the battery, making sure the plus (+) sign on the battery is on the same

side as the plus sign on the clip.

5 Insert the battery clip into the memory card, holding the clip as oriented in the

figure. (Face the open edge of the clip toward the memory card’s write-protect

switch.)

6 Write the date the battery was replaced on the card.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 175 176

Sem comentários

Agilent Technologies 71501D Manual do Utilizador Página 119