Agilent Technologies U1211A Manual do Utilizador Página 1

Agilent TechnologiesAgilent U1211A, U1212A, and U1213A Clamp MeterQuick Start GuideThe following items are included with your clamp meter:✔Standard te

Quick Start GuidePerforming Diode MeasurementConnectProbe and read1 Set the rotary switch to .2 Connect the red and black test leads to input termina

Quick Start GuidePerforming Capacitance MeasurementProbeand readPressConnectCAUTIONCAUTIONDischarge the capacitors before performing the measurements

Quick Start GuidePerforming Temperature MeasurementConnectPress twiceProbe and readFor U1212A and U1213A only1 Set the rotary switch to Ω.2 Press Shif

Quick Start GuideReplacing the Battery1 Set the rotary switch to OFF.2 Disconnect test leads from the input terminal.3 Loosen the screw on the battery

Quick Start GuideRegulatory MarkingsThe CE mark is a registered trademark of the European Community. This CE mark shows that the product complies wit

Quick Start Guide

Safety Notices Safety SymbolsCAUTIONCAUTIONA CAUTION notice denotes a hazard. It calls attention to an operating procedure, practice, or the like that

Printed in MalaysiaU1211-90011Third Edition, June 14, 2012© Agilent Technologies, Inc., 2009–2012Agilent Technologies

Quick Start GuideKnowing Your Clamp MeterClamp jawHandleHand guardAnnunciatorJaw markingsRotary switchFunction buttonsHold/ Max Min buttonRed input te

Quick Start GuideFunctions and FeaturesRotary switchFunction buttons[1] Duty cycle % function is only available for U1213A.Measurements and power off

Quick Start GuideAnnunciator DisplayNo. Annunciator Status1 AUTO Indicates auto ranging2 Zeroing mode3 DH Data hold4 MAX AVG MIN Dynamic recording mod

Quick Start GuideInput Terminals[1] DC current measurement is only available for U1212A and U1213A.[2] Temperature function is only available for U121

Quick Start GuidePerforming Current MeasurementWARNINGEnsure the test leads are disconnected from the input terminals when measuring current with the

Quick Start GuideCAUTIONCAUTIONEnsure that the clamp meter measures only one conductor at a time. Measuring multiple conductors may cause inaccuracy

Quick Start GuidePerforming Voltage MeasurementPressConnect1 Set the rotary switch to ~V.2 Connect the red and black test leads to input terminals V (

Quick Start GuidePerforming Resistance Measurement and Continuity TestConnectProbeand readAudible continuity1 Set the rotary switch to Ω.2 Connect the