Agilent Technologies N1022A Manual do Utilizador descarregar pdf (Página 2)

Probes

Agilent offers a wide variety of probes with the bandwidth

and connectivity required for high-speed waveform

analysis. These include differential and single-ended

probes with solder in, socketed, SMA, and browsing

probe heads offering variable spacing probe tips for

today’s high-density IC’s and circuit boards. Typical

bandwidths are available from 1.5 to 13 GHz (9/05).

All probes have a flat frequency response over the

entire probe bandwidth to eliminate distortion and

frequency-dependent loading effects.

Connecting the probe to the oscilloscope

The precision 3.5 mm connector used for the electrical

channels of several 86100 plug-in modules is not directly

compatible with the standard probe interface of Agilent

real-time sampling oscilloscopes. This problem is solved

with the N1022A Probe Adapter. The N1022A Probe

Adapter provides power, calibration, and a high-integrity

signal path between the probe and the 861XX series

plug-in module. The interface of the probe amplifier

section attaches to one side of the adapter. The other

side of the probe adapter is an instrumentation grade

3.5 mm connector that attaches to the bulkhead male

3.5 mm connector of the electrical channel of the

oscilloscope plug-in module. For power and identification,

an interface cable from the probe adapter attaches to

the probe power port of the oscilloscope plug-in.

Figure 1: infiniimax probes

Figure 2: Connecting a probe through the N1022A adapter

N1022A

Probe amplifier

1 2 3 4 5 6 7

Sem comentários

Agilent Technologies N1022A Manual do Utilizador Página 2