Agilent Technologies E1326B Manual do Utilizador descarregar pdf (Página 23)

Setting the Card ID Switch

The multiplexer module can be an Agilent E1351A, Agilent E1352A or

Agilent E1353A depending on which terminal module is installed. With a

normal connection, the terminal module will automatically configure the

module for the appropriate model. To identify a module without a terminal

module, set the Card ID switch as shown in Figure 2-6. The ID numbers

are:

Model Value Configuration

E1351A 0 all pins open

E1352A 8 pin 3 closed

E1353A 2 pin 1 closed

For normal connections, leave the switch at the factory setting which is all

pins open.

Figure 2-6. Card ID Switch

Chapter 2 Configuring the Agilent E1351A/53A FET Multiplexer Modules 21

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 109 110

Sem comentários

Agilent Technologies E1326B Manual do Utilizador Página 23