Agilent Technologies E1356A Manual de Serviço descarregar pdf (Página 13)

WARNING

USING AUTOTRANSFORMERS. If the mainframe is to be

energized via an autotransformer (for voltage reduction) make

sure the common terminal is connected to neutral (that is, the

grounded side of the main’s supply).

CAPACITOR VOLTAGES. Capacitors inside the mainframe may

remain charged even when the mainframe has been

disconnected from its source of supply.

USE PROPER FUSES. For continued protection against fire

hazard, replace the line fuses only with fuses of the same

current rating and type (such as normal blow, time delay, etc.).

Do not use repaired fuses or short-circuited fuseholders.

Cautions This section contains CAUTIONS which must be followed to avoid damage

to the equipment when performing instrument maintenance or repair.

CAUTION

MAXIMUM VOLTAGE/CURRENT. The maximum voltage that may

be applied between any connector pin and any other point, shield, or

chassis is 15 VPeak.

STATIC ELECTRICITY. Static electricity is a major cause of

component failure. To prevent damage to the electrical components in

the FET Multiplexer, observe anti-static techniques whenever working

on a FET Multiplexer.

General Information 1-3

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

Sem comentários

Agilent Technologies E1356A Manual de Serviço Página 13