Agilent-technologies FS2010 Manual do Utilizador

FuturePlus Systems Corporation FS2010 Users Manual For use with Agilent Logic Analyzers

10 The following explains how to connect the logic analyzer to the FS2010

11 To install the FS2010 software, insert the diskette labeled 16700/702

12 The 1680/90/900 Analyzer is a PC based application that requires a PC r

13 Data that is saved on a 167xx analyzer in fast binary format, or 1

14 After clicking “next” you must browse for the fast binary data file y

15 After the decoder has loaded, select Preferences if required, from t

16 The FS2010 diskette sets up the format menu as shown in the following

17 Loading the configuration file will automatically load the PCI-X Transa

18 FS2010 Software and Timing mode The FS2010 Decoder should NOT be

19 The CYCLE variable is made up of the following signals: TRDY#, FRAME

2 How to reach us ...

20 The TERM CODE variable is made up of DEVSEL#, TRDY#, and STOP#. The f

21 State Analysis This chapter explains how to configure the FS2010 to p

22 For full analysis, the PCI-X workspace should appear as below.

23 Captured data is as shown in the following figure. The below figure d

24 T The above figure shows the listing from th

25 The FS2010 generates one output column that is sub-divided into the fo

26 Timing Analysis Since the FS2010 interface does not buffer the PCI-X b

27 Captured data is displayed as shown in the following figure.

28 Transaction Viewer The FS2010 Protocol Decoder version 2.0 or higher i

29 General Information This chapter provides additional reference informa

3 Use of EyeFinder/Eyescan ...

30 Due to the FS2010 being an interposer all signals are extended 1.2 in

31 J2 Signal Connector Signal Name/Logical Signal name Logic Analyzer cha

32 Signal Name/Logical Signal name Logic Analyzer channel number SAMTEC P

33 J3 Signal Connections Signal Name/Logical Signal name Logic Analyzer

34 Signal Name/Logical Signal name Logic Analyzer channel number SAMTEC

35 J4 Signal Connections Signal Name/Logical Signal name Logic Analyzer

36 Signal Name/Logical Signal name Logic Analyzer channel number SAMTEC P

4 How to reach us For Technical Support: FuturePlus Systems Corporation 3

5 Product Warranty This FuturePlus Systems product has a warranty against d

6 Introduction The FS2010 is a 32/64 bit, 0 to 133Mhz PCI-X State and Timi

7 Analyzing the PCI-X Local Bus This chapter introduces you to the FS2010

8 This operating manual uses the same signal notation as the PCI-X LOCAL

9 *For 32 bit analysis load the timing or state configuration file into